3com Network Router 6000 Owner's Manual download pdf (Page 26)

26 Chapter 2: Installation

AC power socket (recommended)

You are recommended to use a three-terminal single-phase power socket

with ground contact, which must be grounded reliably. Normally, the

ground contact of the power supply system in a building was buried

during construction and cabling. Still, before connecting the AC-input

power cord, you must make sure that the power supply of the building is

well grounded.

Console Terminal

Cable

Console port

The Router 6000 provides an RS232 asynchronous serial console port

(CON) for router configuration. For its attributes refer to “The RPU

Module” or “The RPU2 Module”.

Console cable

A console cable is an eight-wire shielded cable. At one end of the cable is

a crimped RJ-45 connector to the console port on the router; at the other

end of the cable is a DB-9 (female) connector to the serial port on the

console terminal.

The following figure illustrates the console cable.

Figure 15 Console cable

Router to LAN

Connection

Ethernet interface

The RPU provides two 100BASE-TX FE interfaces. For their attributes,

refer to the section “The RPU Module”.

The RPU2 provides three 10/100/1000 Mbps auto-sensing Ethernet

interfaces that each accommodate an RJ-45 connector and an SFP

module respectively for electrical and optical connections.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 59 60

No comments

3com Network Router 6000 Owner's Manual Page 26