3com 3C17300 Owner's Manual download pdf (Page 41)

Manually Configuring IP Information 41

Figure 12 Example top-level command line interface menu

3 At the Select menu option prompt you can either:

■ enter the protocol ip basicConfig command. At the Enter

configuration method prompt enter manual. The screen

prompts you to enter IP information.

■ enter the gettingStarted command. At the Enter

configuration method prompt enter manual. The screen

prompts you to enter IP information.

4 Enter the IP address, subnet mask, and gateway IP address for the Switch.

The screen displays a summary of the information entered.

The initial set up of your Switch is now complete and the Switch is ready

for you to set up your chosen management method. See “Methods of

Managing a Switch” on page 45.

If you do not intend to use the command line interface via the console

port to manage the Switch, you can disconnect the serial cable and close

the terminal emulator software.

Menu options: --------------3Com Superstack 3 Switch 4200---------------

bridge - Administer bridge-wide parameters

gettingStarted - Basic device configuration

logout - Logout of the Command Line Interface

physicalInterface - Administer physical interfaces

protocol - Administer protocols

security - Administer security

system - Administer sytem-level functions

trafficManagement - Administer traffic management

Type ? For help

-------------------------------(1)-----------------------------------

Select menu option:

DUA1730-0AAA02.book Page 41 Thursday, January 23, 2003 12:28 PM

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 83 84

No comments

3com 3C17300 Owner's Manual Page 41