3com 2226 PLUS Owner's Manual download pdf (Page 54)

54 CHAPTER 4: CONFIGURING THE SWITCH

Detail

Use the Detail tab to display detailed port

setting information for a port.

Figure 38 Port Administration Detail Screen

Setup

Use the Setup tab to configure the port

settings. The following options are available:

■ Port State – Enables and disables the port.

■ Flow Control – Enables and disables flow

control on the port. When flow control is

enabled for the port, the Switch regulates

the packet flow so that a sending device

does not transmit more packets than a

receiving device can process. If flow control

is disabled, packets may be dropped under

certain periods of high traffic.

Flow control is disabled by default.

■ Speed – Sets the speed mode of the port.

Available options include auto, 10, 100, and

1000. For 1000 Mbps connections, see

“Speed/Duplex for 1000 Mbps

Connections” below.

Auto (or autonegotiation) sets the optimum

combination of speed and duplex that can

be supported by both ends of the link.

■ Duplex – Sets the duplex mode of the port.

Available options include auto, half, and full.

CAUTION: It is advised not to enable Flow

Control on ports that will be connected to

telephony and other time sensitive traffic as it

may hamper the QoS performance.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 93 94

Comments to this Manuals

No comments